Accurate & Verified 2023 New 350-501 Answers As Experienced in the Actual Test!
350-501 Certification Sample Questions certification Exam
NEW QUESTION # 85
Refer to the exhibit. A network engineer at ISP-B must advertise 198.19.100.0/24 -
198.19.105.0/24 prefixes to ISP-A with these requirements:
- Prefixes 198.19.100.0/24 - 198.19.102.0/24 must have the community
set to 64602:10.
- Prefixes 198.19.103.0/24 - 198.19.105.0/24 must have the community
set to 64602:11.
- The AS_PATH for the 198.19.103.0/24 - 198.19.105.0/24 prefixes must
appear as "64602 64602" in ASN 64601.
Which configuration must the engineer implement on the ISP-B router to meet the requirements?
- A. configure terminal
access-list 30 deny 198.19.100.0 0.0.0.255
access-list 30 deny 198.19.101.0 0.0.0.255
access-list 30 deny 198.19.102.0 0.0.0.255
!
route-map ASN-64601-OUT permit 10
match ip address 30
set as-path prepend 64602 64602
set community 64602:11
route-map ASN-64601-OUT permit 20
set community 64602:10
end - B. configure terminal
access-list 30 deny 198.19.103.0 0.0.0.255
access-list 30 deny 198.19.104.0 0.0.0.255
access-list 30 deny 198.19.105.0 0.0.0.255
!
route-map ASN-64601-OUT deny 10
match ip address 30
set as-path prepend 64602
set community 64602:11
route-map ASN-64601-OUT permit 20
set community 64602:10
end - C. configure terminal
access-list 30 deny 198.19.100.0 0.0.0.255
access-list 30 deny 198.19.101.0 0.0.0.255
access-list 30 deny 198.19.102.0 0.0.0.255
access-list 30 permit any
!
route-map ASN-64601-OUT permit 10
set community 64602:10
!
route-map ASN-64601-OUT permit 20
match ip address 30
set as-path prepend 64602 64602
set community 64602:11
end - D. configure terminal
access-list 30 deny 198.19.100.0 0.0.0.255
access-list 30 deny 198.19.101.0 0.0.0.255
access-list 30 deny 198.19.102.0 0.0.0.255
access-list 30 permit any
!
route-map ASN-64601-OUT permit 10
match ip address 30
set as-path prepend 64602
set community 64602:11
route-map ASN-64601-OUT permit 20
set community 64602:10
end
Answer: D
NEW QUESTION # 86
How is a telemetry session established for data analytics?
- A. A router initiates a session using the dial-out to a destination.
- B. The destination initiate a session using the dial-out more to the router.
- C. A router requests the data using Teinet.
- D. A destination initiate a session to a router.
Answer: B
NEW QUESTION # 87
Refer to the exhibit.
A network engineer Is implementing OSPF multiare
a. Which command on interface G0/1 resolves adjacency Issues in the new area?
- A. Ip ospf network non-broadcast
- B. Ip ospf network polnt-to-multlpoint
- C. Ip ospf network point-to-point
- D. Ip ospf network broadcast
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_ospf/configuration/xe-16/iro-xe-16-book/iro-multi-area-adj-xe.html
NEW QUESTION # 88
Refer to the exhibit. EIGRP a running across the core lo exchange Internal routes, and each router maintains 6GP adjacency with the other routers on the network. An operator has configured static routes on the edge routers R1 and R2 for IP address 10.0.1.1. which is used as a black hole route as shown. Which configuration should the operator Implement to me management rouler to create a route map that will redistribute lagged static routes into BGP and create a static route to blackhole traffic with tag 777 that Is destined to server at 192.168.10.100?
- A. Option C
- B. Option D
- C. Option A
- D. Option B
Answer: B
NEW QUESTION # 89
Refer to the exhibit:
Which two statements about the ISIS topology are true? (Choose two.)
- A. All four routers are operating as Level 1 routers only.
- B. R1 and R4 are Level 2 neighbors
- C. All four routers are operating as Level 1-2 routers.
- D. All four routers are operating as Level 2 routers only.
- E. R1 and R2 are Level 2 neighbors.
Answer: B,C
NEW QUESTION # 90
Drag and drop the OSs from the left onto the correct deceptions on the right.
Answer:
Explanation:
NEW QUESTION # 91
Refer to the exhibit:
You are configuring an administrative domain implement so that devices can dynamically learn the RP?
- A. Auto-RP
- B. BSR
- C. BID1R-PIM
- D. SSM
Answer: A
NEW QUESTION # 92
Refer to the exhibit. Which show command should be implemented to display per-interface statistics about uRPF drops and suppressed drops?
- A. show ip interface brief
- B. show ip traffic
- C. show ip interface
- D. show cef interface
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_data_urpf/configuration/xe-3s/sec-data- urpf-xe-3s-book/cfg-unicast-rpf.html
NEW QUESTION # 93
Refer to the exhibit.
Refer to the exhibit. Tier 2 ISP A on AS 653 is connected to two Tier 1 ISPs on AS 321 and AS 51 respectively. The network architect at ISP A is planning traffic flow inside the network to provide predictable network services. Cisco Express Forwarding is disabled on the edge router. How should the architect implement BGP to direct all traffic via the Tier 1 ISP with next-hop 7.4.5.2?
- A. Implement BGP route-reflector functionality with the bgp always-compare-med configuration.
- B. Implement MP-BGP with a 4-byte AS number with the bgp best path compare-routerid command.
- C. Implement the BGP routing protocol and run the bgp deterministic-med command.
- D. Implement the BGP routing protocol and the maximum-paths 2 configuration.
Answer: C
NEW QUESTION # 94
An engineer Is implementing NSR with OSPF on a large campus that requires high availability. Which task must an engineer perform to complete the process with minimal disruption to traffic?
- A. Ensure that the dual RP has synchronized their state information before performing the switchover operation.
- B. Reset OSPF neighbor sessions to maintain state Information during router switchover
- C. increase the keepalive interval on the OSPF neighbors so that traffic continues to pass during the switchover.
- D. Configure the device to repopulate state information using routing updates received from the BDR
Answer: A
NEW QUESTION # 95
Refer to the exhibit:
Which statement supports QPPB implementation?
- A. QoS policies are identified in the MPLS forwarding table
- B. QPPB policies affect only egress traffic
- C. QoS policies rely exclusively on BGP attributes to manipulate traffic
- D. QoS policies use BGP to gain full coverage on the network.
Answer: C
NEW QUESTION # 96
Refer to the exhibit.
An engineer is configuring path selection on router R1 for two ASNs as shown. Which additional task must the engineer perform on Router 1 so that all outbound traffic utilizes the link between R1 and R3 to reach ASN 4567?
- A. Configure a high med on the peer to ASN 4567.
- B. Configure an AS path prepend on the peer to ASN 4567.
- C. Configure a high weight on the peer to ASN 4567.
- D. Configure a low weigh! on the peer to ASN 4567.
Answer: C
NEW QUESTION # 97
Drag and drop the NAT64 descriptions from the left onto the correct NAT64 types on the right.
Answer:
Explanation:
Explanation
Stateful (It has 1: N translation, It uses address overloading, It conservers IPv4 addresses) Stateless (It is limited on the number of endpoints, It mandates IPv4-translatable IPv6 address allocation)
NEW QUESTION # 98
A network team has failed to implement IS-IS multitopology. What is the reason for it?
- A. The router did not support VRFs.
- B. The router did not have Cl$co Discovery Protocol and Cisco Express Forwarding disabled.
- C. The routing process did not support extended metrics.
- D. The routing process supported Level 1 only.
Answer: C
NEW QUESTION # 99
Drag and drop the functions from the left onto the Path Computation Element Protocol roles on the right.
Answer:
Explanation:
NEW QUESTION # 100
Refer to the exhibit:
Which statement about this configuration is true"?
- A. It is the configuration for the head-end router of a Cisco MPLS TE tunnel with segment routing
- B. It requires an explicit Cisco MPLS TE path to be configured for the tunnel to run
- C. It requires OSPF to also be running to have optimized Cisco MPLS TE tunnels
- D. It requires a dynamic Cisco MPLS TE path to be configured for the tunnel to run
Answer: A
NEW QUESTION # 101
Refer to the exhibit:
A network administrator wants to enhance the security for SNMP for this configuration.
Which action can the network administrator implement?
- A. Re-configure to use SNMPv2 with MD5 authentication
- B. Maintain the configuration but switch to an encrypted password for device access through SSH
- C. Add a community string to the existing entry
- D. Re-configure to use SNMPv3.
Answer: D
NEW QUESTION # 102
Refer to the exhibit:
P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.
Which statement about the architecture is true?
- A. To support seamless MPLS. TDP must be used as the label protocol
- B. To support seamless MPLS, the BGP route reflector feature must be disabled
- C. If each area is running its own IGP. BGP must provide an end-to-end MPLS LSP
- D. If each area is running its own IGP. the ABR routers must redistribute the IGP routing table into BGP
Answer: C
NEW QUESTION # 103
......
Certification Topics of 350-501 Exam PDF Recently Updated Questions: https://www.realvce.com/350-501_free-dumps.html
350-501 Exam Prep Guide: Prep guide for the 350-501 Exam: https://drive.google.com/open?id=1xP8lCjkKqzvl5Rhj0Ajl-hkjgHC89Oj4