Get Cisco 350-501 Dumps Questions Study Exam Guide Sep 06, 2024
350-501 Premium Exam Engine - Download Free PDF Questions
NEW QUESTION # 85
Which CLI mode must be used to configure the BGP keychain in Cisco IOS XR software?
- A. BGP neighbor configuration
- B. global configuration mode
- C. mode BGP address-family configuration mode
- D. routing configuration mode
Answer: B
NEW QUESTION # 86
An engineer is implementing a Cisco MPLS TE tunnel to improve the streaming experience for the clients of a video-on-demand server. Which action must the engineer perform to configure extended discovery to support the MPLS LDP session between the headend and tailend routers?
- A. Configure a Cisco MPLS TE tunnel on both ends of the session.
- B. Configure the interface bandwidth to handle TCP and UDP traffic between the LDP peers.
- C. Configure a targeted neighbor session.
- D. Configure an access list on the interface to permit TCP and UDP traffic.
Answer: A
Explanation:
https://community.cisco.com/t5/mpls/mpls-te-tunnel-targeted-ldp-session/td-p/2863558
NEW QUESTION # 87
Which action occurs during the traceback phase of the six-phase approach to service provider security?
- A. Review the whole attack-handling process
- B. Detect unusual activity or behavior and activate appropriate measures after an alert is raised.
- C. Mitigate the attack that flows using various mechanisms.
- D. Trace action occur flows from the stacked sections of the network toward the network edges
Answer: D
Explanation:
During the traceback phase of the six-phase approach to service provider security, the action that occurs is tracing the attack flows from the attacked sections of the network toward the network edges. This phase entails identifying the source of the attack by analyzing the path that the attack traffic has taken through the network.
NEW QUESTION # 88
Drag and drop the LDP features from the left onto their usages on the right.
Answer:
Explanation:
NEW QUESTION # 89
Refer to the exhibit.
An engineer ran this show telemetry command to view subscription SUB11 on RouterX. The engineer then decided that RouterY should provide the same output lor sensor group SGroup13 as RouterX. The engineer cannot access RouterX to copy its configuration No access lists on the router block user access Which configuration must the engineer apply on RouterY to provide the same output from the show telemetry command?
- A.
- B.
- C.
- D.
Answer: A
NEW QUESTION # 90
Drag and Drop Question
Drag and drop the technologies from the left onto the correct definitions on the right.
Answer:
Explanation:
NEW QUESTION # 91
After a series of unexpected device failures on the network. a Cisco engineer is deploying NSF on the network devices so that packets continue to be forwarded during switchovers The network devices reside in the same holding, but they are physically separated into two different data centers Which task must the engineer perform as part of the deployment?
- A. implement VRFs and specify the forwarding instances that must remain active during failover.
- B. implement Cisco Express Forwarding to provide forwarding during failover
- C. implement OSPF to maintain the link-state database during failover.
- D. implement an L2VPN with the failover peer to share state Information between the active and standby devices.
Answer: A
NEW QUESTION # 92
Refer to the exhibits:
R1 and R2 are directly connected and IS-IS routing has been enabled between R1 and R2 R1 message periodically Based on this output, which statement is true?
- A. IS-IS neighbor authentication is failing for Level 2 PDUs only.
- B. 1S-1S neighbor authentication is failing for Level 1 and Level 2 PDUs .
- C. IS-IS neighbor authentication is failing for Level 1 PDUs only
- D. IS-IS neighbor authentication is failing for Level 2 first and then for Level 1 PDUs
Answer: C
NEW QUESTION # 93
Refer to the exihibit.
router(config)# route-map blackhole-trigger
router(config-route-map)# match tag 777
router(config-route-map)# set ip next-hop 10.0.1.1
router(config-route-map)# set origin igp
router{config-route-map)# set community no-export
Refer to the exhibit. EIGRP is running across the core to exchange internal routes, and each router maintains iBGP adjacency with the other routers on the network. An operator has configured static routes on the edge routers R1 and R2 for IP address 10.0.1.1, which is used as a black hole route as shown. Which configuration should the operator implement to the management router to create a route map that will redistribute tagged static routes into BGP and create a static route to blackhole traffic with tag 777 that is destined to the server at 192.168.10.100?
- A. router(config)# router bgp 55100
router(config-router)# redistribute static route-map blackhole-trigger
router(config)# ip route 10.0.1.1 255.255.255.255 Null0 tag 777 - B. router(config)# router bgp 55100
router(config-router)# redistribute connected route-map blackhole-trigger router(config)# ip route 192.168.10.100 255.255.255.255 Null0 tag 777 - C. router(config)# router bgp 55100
router(config-router)# redistribute static route-map blackhole-trigger
router(config)# ip route 192.168.10.100 255.255.255.255 Null0 tag 777 - D. router(config)# router bgp 55100
router(config-router)# redistribute connected
router(config)# ip route 192.168.10.100 255.255.255.255 tag 777
Answer: C
NEW QUESTION # 94 
Refer to the exhibit. While troubleshooting the OSPF adjacency between routers R1 and R2, an engineer noticed that both routers are stuck in the EXCHANGE/EXSTART state. What should the engineer fix to solve the ongoing issue?
- A. match OSPF areas
- B. match IPv4 addresses
- C. match OSPF network types
- D. match MTU values
Answer: D
Explanation:
Section: Networking
NEW QUESTION # 95
Refer to the exhibit:
Which configuration prevents the OSPF neighbor from establishing?
- A. mtu
- B. network statement
- C. default-metric
- D. duplex
Answer: A
NEW QUESTION # 96
Refer to the exhibit. Router BRDR-1 is configured to receive the 0.0.0.0/0 and 172.17.1.0/24 networks via BGP and advertise them into OSPF area 0. An engineer has noticed that the OSPF domain is receiving only the 172.17.1.0/24 route and default route 0.0.0.0/0 is still missing. Which configuration must an engineer apply to resolve the problem?
- A. router ospf 1 default-information originate end
- B. router ospf 1 default-information originate always end
- C. router ospf 1 default-metric 100 end
- D. router ospf 1 redistribute bgp 65001 metric 100 route-policy BGP-TO-OSPF end
Answer: A
Explanation:
We receives default route via BGP. If we loose it we should stop to announce it into OSPF domain. But if you set "default-information originate always" the default route will remain. So the best choice is to use the "default-information originate".
NEW QUESTION # 97
Which configuration modifies Local Packet Transport Services hardware policies?
A)
B)
C)
D)
- A. Option B
- B. Option D
- C. Option A
- D. Option C
Answer: D
NEW QUESTION # 98
Refer to the exhibit. Which effect of this configuration is true?
- A. R1 can support a graceful restart operation on the peer, even if graceful restart is disabled on the peer
- B. R1 can failover only to a peer that is configured for LDP SSO/NSF
- C. R1 can failover to any peer
- D. R1 can support a peer that is configured for LDP SSO/NSF as the peer recovers from an outage
Answer: D
Explanation:
https://www.cisco.com/en/US/docs/general/Test/kwoodwar/fsgr29s.html
NEW QUESTION # 99
An engineer is implementing MPLS to monitor within the MPLS domain. Which must the engineer perform to prevent packets from being forwarded beyond the service provider domain when the LSP is down?
- A. Option B
- B. Option C
- C. Option D
- D. Option A
Answer: C
Explanation:
To prevent packets from being forwarded beyond the service provider domain when the Label Switched Path (LSP) is down, the engineer must configure a private IP address as the destination address of the headend router of Cisco MPLS Traffic Engineering (TE). This ensures that if the LSP fails, the packets will not be routable over the public internet, thus containing them within the service provider's network.
NEW QUESTION # 100
......
Free 350-501 Exam Braindumps Cisco Pratice Exam: https://www.realvce.com/350-501_free-dumps.html
Instant Download 350-501 Free Updated Test Dumps: https://drive.google.com/open?id=1jlIKkr80wXT_ImW2RUGmVbz_k2Qsl3-j