Many people know getting Cisco certification is very useful for their career but they fear failure because they hear it is difficult. Now I advise you to purchase our 640-822 premium VCE file. If you are not sure you can download our 640-822 VCE file free for reference. Please trust me if you pay attention on our 640-822 dumps VCE pdf you will not fail. We can guarantee you pass 640-822 exam 100%.
Why do we have this confidence to say that we are the best for 640-822 exam and we make sure you pass exam 100%? Because our premium VCE file has 80%-90% similarity with the real Cisco 640-822 questions and answers. Once you finish our 640-822 dumps VCE pdf and master its key knowledge you will pass 640-822 exam easily. If you can recite all 640-822 dumps questions and answers you will get a very high score. Our standard is that No Help, Full Refund. No pass, No pay.
Instant Download: Our system will send you the 640-822 braindumps file you purchase in mailbox in a minute after payment. (If not received within 12 hours, please contact us. Note: don't forget to check your spam.)
Cisco Interconnecting Cisco Networking Devices Part 1 Sample Questions:
1. Which three statements are correct about RIP version 2? (Choose three)
A) It has a lower default administrative distance than RIP version 1
B) It uses broadcast for its routing updates
C) It does not send the subnet mask un updates
D) It has the same maximum hop count as version 1
E) It is a classless routing protocol
F) It supports authentication
2. To what type of port would a cable with a DB-60 connector attach?
A) Ethernet port
B) console port
C) fiber optic port
D) serial port
3. Refer to the exhibit. What could be possible causes for the "Serial0/0 is down" interface status? (Choose two.)
A) A Layer 1 problem exists.
B) An incorrect cable is being used.
C) The bandwidth is set too low.
D) A protocol mismatch exists.
E) There is an incorrect IP address on the Serial 0/0 interface.
4. Which IOS command results in the output shown in the following?
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
A) router# configure terminal
B) router# configure memory
C) router# copy startup-config running-config
D) router# setup
E) router# copy running-config startup-config
5. Given an IP address of 192.168.1.42 255.255.255.248, what is the subnet address?
A) 192.168.1.8/29
B) 192.168.1.48/29
C) 192.168.1.32/27
D) 192.168.1.16/28
E) 192.168.1.40/29
Solutions:
| Question # 1 Answer: D,E,F | Question # 2 Answer: D | Question # 3 Answer: A,B | Question # 4 Answer: D | Question # 5 Answer: E |
